[ANSYS Meshing] Take a lot of time for meshing

chienfm · October 15, 2012, 11:51

Hi everybody,

I have a problem with my project that meshing always take a lot of time (more than 2 days for attach geometry). My hardware and meshing mode are following :

- Hardware : Xeon - 1230 3.3 Ghz , Ram 16 Gb, SSD - 128Gb ( 50 Gb remain )
- Meshsing : Proximity and Curvature at Medium Relevence Center
- The Geometry was created in solidwork.

Can you help me how to reduce meshing time. Any problem with my modeling ?

Thank you !

diamondx · October 17, 2012, 16:26

how many cells you get your mesh is generated. look at the unit, make sure you your sizing is not too small...

October 17, 2012, 16:26		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 29	how many cells you get your mesh is generated. look at the unit, make sure you your sizing is not too small... __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Time step size and max iterations per time step	pUl\|	FLUENT	31	October 23, 2020 23:50
Hydrostatic Pressure and Gravity	miliante	OpenFOAM Running, Solving & CFD	132	October 7, 2012 23:50
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3	bookie56	OpenFOAM Installation	8	August 13, 2011 05:03
air bubble is disappear increasing time using vof	xujjun	CFX	9	June 9, 2009 08:59
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 15:09