 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Question about mesh generation for a pipe inside a cube |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 10, 2012, 13:28
|
Question about mesh generation for a special case
|
#1 |
|
Senior Member
lnk
Join Date: Feb 2011
Location: Switzerland
Posts: 118
Rep Power: 15  |
Hi,
I'm working on the mesh generation for a special case by ICEM. The fluid domain is a pipe inside a cube. And the cube edge is tangential to the circle. I decide to use O-grid. But since the some of the connection part between the pipe and the cube is infinitely small. I always have bad quality over there. Could someone tell me how to solve this problem?  Best regards and many thanks. lnk Last edited by lnk; July 11, 2012 at 08:01. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 07:21 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 07:42 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
| QUESTION IN GENERATION OF BODY-FITTED MESH | James Zhu | Main CFD Forum | 0 | September 19, 2000 05:06 |
| unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 11:09 |
Linear Mode
