[ANSYS Meshing] Meshing advice needed??

carolann · June 26, 2012, 02:54

Hi,

I am to do a study on spray droplet sizes. I need to create & mesh a spray chamber using Design Modeler & ANSYS meshing. Can someone advice me on how to start this? Thanks!

Far · June 26, 2012, 03:34

First do the Tutorials. Send an email, I will send you DM and AM training notes.

carolann · June 26, 2012, 04:43

Thanks for replying =)

Well, I've tried some tutorials before this. And after that, went on to try to work on my case...but I can't seem to create the geometry correctly. Creating the spray chamber is fine, it's just a cylinder. But incorporating the injector nozzle exit at the starting end is what I'm having difficulty with.

carolann · June 26, 2012, 06:30

Hi,

I'm not sure if you have received my email. You may send the training notes to me at carol.skye@gmail.com

Thanks a lot.

June 26, 2012, 02:54	Meshing advice needed??	#1
carolann New Member Join Date: Jun 2012 Posts: 4 Rep Power: 14	Hi, I am to do a study on spray droplet sizes. I need to create & mesh a spray chamber using Design Modeler & ANSYS meshing. Can someone advice me on how to start this? Thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help needed with Meshing of Terrain Data	syler3321	Main CFD Forum	2	July 27, 2011 02:32
Dynamic Meshing Tutorial (Valve.c) needed	techy	Fluent UDF and Scheme Programming	0	January 26, 2011 01:18
Prism layer advice needed for steady state port flow case	MaxCFM	Main CFD Forum	1	October 1, 2009 10:26
Hardware extension advice needed	Luk	CFX	7	February 2, 2009 19:05
advice needed in solving linear system	yf yap	Main CFD Forum	5	February 5, 2001 01:21

June 26, 2012, 03:34		#2
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	First do the Tutorials. Send an email, I will send you DM and AM training notes.

June 26, 2012, 04:43		#3
carolann New Member Join Date: Jun 2012 Posts: 4 Rep Power: 14	Thanks for replying =) Well, I've tried some tutorials before this. And after that, went on to try to work on my case...but I can't seem to create the geometry correctly. Creating the spray chamber is fine, it's just a cylinder. But incorporating the injector nozzle exit at the starting end is what I'm having difficulty with.

June 26, 2012, 06:30		#4
carolann New Member Join Date: Jun 2012 Posts: 4 Rep Power: 14	Hi, I'm not sure if you have received my email. You may send the training notes to me at carol.skye@gmail.com Thanks a lot.