[ICEM] cylinder meshing

tmeysam92 · June 24, 2012, 13:38

Hi all,

how can i mesh the cylinder like the the attached file, but without the center block, i mean it meshed all radial.
is it possible?

thanks in advance.
meysam

Far · June 24, 2012, 15:34

which center block

tmeysam92 · June 25, 2012, 04:34

Hi Far,

sorry for delay.

i mean when i create the block around the cylinder and then split(o grid) and associate them, at last there is a cube block in the center that has a quad mesh,

i mean how can i delete the center block, to have a complete radial mesh.

Far · June 25, 2012, 04:58

OK. Just delete that block with permanent option unchecked (to send it to VORFN) or right click on parts and crate new part. Go to last option and select the inside cube block and name it as Solid. From parts list, un-check solid.

June 24, 2012, 13:38	cylinder meshing	#1
tmeysam92 Senior Member tmeysam92 Join Date: Jun 2011 Posts: 135 Rep Power: 15	Hi all, how can i mesh the cylinder like the the attached file, but without the center block, i mean it meshed all radial. is it possible? thanks in advance. meysam

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
meshing on cylinder fails ICEM	potac	ANSYS Meshing & Geometry	0	October 25, 2011 06:21
2D planar cylinder meshing problem	saisanthoshm88	ANSYS Meshing & Geometry	15	December 27, 2010 12:14
[ICEM] (ICEM CFD) meshing over a cylinder	vmlxb6	ANSYS Meshing & Geometry	6	August 11, 2010 15:37
[blockMesh] Meshing inside a cylinder so that the edges contain more cells than the center	Bertrand	OpenFOAM Meshing & Mesh Conversion	1	April 13, 2010 05:46
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 12:03

June 24, 2012, 15:34		#2
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	which center block

June 25, 2012, 04:34		#3
tmeysam92 Senior Member tmeysam92 Join Date: Jun 2011 Posts: 135 Rep Power: 15	Hi Far, sorry for delay. i mean when i create the block around the cylinder and then split(o grid) and associate them, at last there is a cube block in the center that has a quad mesh, i mean how can i delete the center block, to have a complete radial mesh.

June 25, 2012, 04:58		#4
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	OK. Just delete that block with permanent option unchecked (to send it to VORFN) or right click on parts and crate new part. Go to last option and select the inside cube block and name it as Solid. From parts list, un-check solid.