|
[Sponsors] |
October 31, 2017, 07:17 |
create layer for airfoil
|
#1 |
Member
ESI
Join Date: Sep 2017
Posts: 49
Rep Power: 9 |
I want to create layer for airfoil. it is same as the below picture. I can not do it. anyone can help me. thank you very much.
I do it on 2D. userguide.JPG userguide1.JPG |
|
November 15, 2017, 06:32 |
|
#2 |
Senior Member
Vangelis Skaperdas
Join Date: Mar 2009
Location: Thessaloniki, Greece
Posts: 287
Rep Power: 21 |
Hi there
You just need to mesh is with CFD mesh and then use Elements>Zonecut [Gradual] to "imprint" the 2D layers |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Adding layer 3d wing (y+=1) | Dorian1504 | OpenFOAM Meshing & Mesh Conversion | 4 | November 10, 2017 00:56 |
[snappyHexMesh] Problem airfoil snappyhexmesh add layer | bye bye my blue | OpenFOAM Meshing & Mesh Conversion | 1 | May 5, 2017 05:56 |
[ANSYS Meshing] Cannot create inflation over entire boundary layer | Azeem | ANSYS Meshing & Geometry | 3 | March 21, 2017 15:37 |
[snappyHexMesh] How to create internal boundaries using snappyHexMesh | robyTKD | OpenFOAM Meshing & Mesh Conversion | 2 | October 19, 2014 09:57 |
[ICEM] Can't create prism layer on 2D extruded mesh | PedroC | ANSYS Meshing & Geometry | 19 | April 19, 2011 20:48 |