|
[Sponsors] |
October 24, 2017, 08:36 |
Error Message by step-output: empty file
|
#1 |
New Member
Xinxin Zhu
Join Date: Oct 2017
Location: Stuttgart
Posts: 10
Rep Power: 8 |
Hi everybody, I encountered a problem by output in step-format.
As the picture below shows, in an assembly I integrate 2 connecting parts into 1 through projecting CONS on the surfaces and delete the unnecessary surfaces. Then probably one part will be failed to be output in step-format. In this case the brown one can't be output with an error message "Error! Empty file", if I choose show only this part and output. This doesn't happen every time. How can I correct it? How to avoid such phenomenon? Thanks a lot |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Custom Thermophysical Properties | wsmith02 | OpenFOAM | 4 | June 1, 2023 14:30 |
[swak4Foam] swak4foam for OpenFOAM 4.0 | mnikku | OpenFOAM Community Contributions | 80 | May 17, 2022 08:06 |
[OpenFOAM.org] Patches to compile OpenFOAM 2.2 on Mac OS X | gschaider | OpenFOAM Installation | 136 | October 10, 2017 17:25 |
[swak4Foam] groovyBC in openFOAM-2.0 for parabolic velocity bc | ofslcm | OpenFOAM Community Contributions | 25 | March 6, 2017 10:03 |
[Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0 | Seroga | OpenFOAM Community Contributions | 9 | June 12, 2015 17:18 |