|
[Sponsors] |
CFD News and Announcements - Message Display |
Post Response | Return to Index | Read Prev Msg | Read Next Msg |
Posted By: | Darshan Patel |
Date: | Mon, 23 Jan 2017, 11:44 a.m. |
The customer, one of the leading manufacturers of high speed rotating machines, asked ADT to carry out the complete aerodynamic design of a brand new centrifugal chiller compressor stage using the inverse design approach available through the TURBOdesign Suite software. Performance targets (Pressure Ratios and Efficiencies) and operating points were set by the customer before the start of the project. Tight requirements on off-design and mechanical performance and the overall size of the stage were also set by the customer.
INITIAL STAGE SIZING
Impeller geometry for final designThe initial meridional shapes and main dimensions for the compressor stage were produced by means of the 1-Dimensional sizing software TURBOdesign Pre. Real gas effects are modelled directly in TURBOdesign Pre, with gas property data included via .rgp files produced using NIST REFPROP data.
3D IMPELLER AND VANELESS DIFFUSER DESIGN
By using the 3D blade design software TURBOdesign1 the blade loading distribution was optimized in order to achieve the target Pressure Ratio at the design mass flow and obtain good compressor impeller efficiency. The compressor requires good efficiency over a very wide operating range, and so a vaneless diffuser design was produced. Vaneless diffuser pinch width and length were optimised as part of the design process.
Designs produced were tested by means of commercial CFD codes. Designs were analysed both at design point and the most challenging off-design points. The final design has also been analysed across the entire operating map, considering different compressor speed lines between 40% and 120% of the design rotational speed.
Stage geometry for final designCFD analysis shows that the final design is reaching all target Pressure Ratios and mass flows, whilst meeting all target efficiencies and exceeding the design point target efficiency (including the Volute) by 2%. Read the consultancy summary in full.
On Wednesday 1st February, we are running a free 1 hour webinar that will show how using the different modules in TURBOdesign Suite you can design high efficiency compressors rapidly from scratch. We will use an example of a small heat pump and show the following design process:
- Creation of real gas property tables (RGP) from REFPRO for the new refrigerant. - Meanline design of the compressor by using TURBOdesign Pre and the RGP files. - 3D design of the impeller by TURBOdesign1. - Optimization of the impeller geometry for multiple operating points by TURBOdesign Optima.
Register for our webinar on Wednesday 1st February to:
- LEARN TURBOdesign suite: a powerful and highly effective design toolset that streamlines the design/optimization process and delivers higher efficiency of a real gas compressor designs meeting the latest requirements.
- DISCOVER how TURBOdesign suite opens up the design space and enables engineers and designers to achieve higher performances over wide operating ranges.
- SEE how fast and easy it is for users to set-up and run TURBOdesign Suite tools – including integrating seamlessly with common CAE environments and running what are normally challenging multipoint optimizations. This webinar is offered several times. Select (click) the time that works best for you.
9am GMT: http://info.adtechnology.co.uk/uk-compressors-webinar-registration 12pm EDT: http://info.adtechnology.co.uk/usa-compressors-webinar-registration
http://blog.adtechnology.co.uk/design-of-chiller-compressor
Post Response | Return to Index | Read Prev Msg | Read Next Msg |