 |
 |
 |
|
|
|
[Sponsors] | ||||
February 26, 2006, 15:18
|
regarding to pistion bowl motion
|
#1 |
|
Guest
Posts: n/a
|
iam doing moving mesh with bowl .while verification bowl is not moving with cylinder.please give solusion for that one.
|
|
|
||
|
February 28, 2006, 06:45
|
Re: regarding to pistion bowl motion
|
#2 |
|
Guest
Posts: n/a
|
colect the vertices of the bowl. Do the following
: make the bowl alone as type 1 : CSET NEWS TYPE 1 VSET NEWS CSET csys 1 *GET IC8 Y 954 VGEN 2 0 VSET,,,0.0,-1 * IC8,0.0 VGEN 2 0 VSET,,,0.0,YPST,0.0 P.s Here 954 is the vertex number on the top of the bowl. You can select the vertex number on the surface of the bowl You add this four line command at the end of .cgrd file ...Hope this will work |
|
|
|
||
|
February 28, 2006, 06:55
|
Re: regarding to pistion bowl motion
|
#3 |
|
Guest
Posts: n/a
|
colect the vertices of the bowl. Do the following
: make the bowl alone as type 1 : CSET NEWS TYPE 1 VSET NEWS CSET csys 1 *GET IC8 Y 954 VGEN 2 0 VSET,,,0.0,-1 * IC8,0.0 VGEN 2 0 VSET,,,0.0,YPST,0.0 P.s Here 954 is the vertex number on the top of the bowl. You can select the vertex number on the surface of the bowl You add this four line command at the end of .cgrd file ...Hope this will work |
|
|
|
||
|
February 28, 2006, 15:55
|
Re: regarding to pistion bowl motion
|
#4 |
|
Guest
Posts: n/a
|
thank you for gave fast reply, i will try for these commands
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mixture model for rotating bowl | garima chaudhary | FLUENT | 1 | January 30, 2008 19:24 |
| Modeling shaking motion Vs Rotational motion | jaswi | OpenFOAM Running, Solving & CFD | 2 | July 19, 2007 23:44 |
| DynamicLayering in Diesel Simul. with Bowl-In Pist | jojo | FLUENT | 0 | April 4, 2006 15:52 |
| C.G. Motion | Giuseppe | FLUENT | 0 | January 24, 2006 14:02 |
| bowl simulation | Ravi Raju | FLUENT | 0 | April 1, 2005 04:19 |
Linear Mode
