A problem in valve analysis

February 22, 2004, 22:33

There is a case for valve analysis .the detail conditions are as follows: (1)spool is tetra mesh and valve sleeve is hexa mesh. (2)spool move 3 mm relatively to sleeve at a speed of 1 mm/s (3)using moving mesh in analysis

I have some puzzles about this case: (1) shall I use ASI method ? (2) can spool be moved by "case.cgrd" through the event step ? (3) shall I couple the spool and sleeve in the events

appendix: spool(»¬·§·§Ð¾) sleeve(·§Ì×)

February 22, 2004, 22:41

I especially want to know (3) : shall I couple the spool and sleeve in the events when using ASI method

February 22, 2004, 22:33	A problem in valve analysis	#1
zhpan Guest Posts: n/a	There is a case for valve analysis .the detail conditions are as follows: (1)spool is tetra mesh and valve sleeve is hexa mesh. (2)spool move 3 mm relatively to sleeve at a speed of 1 mm/s (3)using moving mesh in analysis I have some puzzles about this case: (1) shall I use ASI method ? (2) can spool be moved by "case.cgrd" through the event step ? (3) shall I couple the spool and sleeve in the events appendix: spool(»¬·§·§Ð¾) sleeve(·§Ì×)

February 22, 2004, 22:41	Re: A problem in valve analysis	#2
zhpan Guest Posts: n/a	I especially want to know (3) : shall I couple the spool and sleeve in the events when using ASI method

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
gap between valve stem valve	kantharao	Siemens	0	September 2, 2008 08:19
Globe Valve Aeroacoustic Analysis	Mohammad Kordi	FLUENT	0	June 2, 2008 05:18
Pressure drop of valve with valve opening of 30%	elogesh	Main CFD Forum	2	January 5, 2007 13:30
Valve seal problem! Urgent	songxguan	Main CFD Forum	0	May 11, 2006 23:04
Flow measurement around intake valve pressure condition problem	fedegavo	OpenFOAM Running, Solving & CFD	1	January 20, 2006 14:06