 |
 |
 |
|
|
|
[Sponsors] | ||||
January 17, 2024, 02:36
|
Regarding stl file
|
#1 |
|
Member
Ajay Jatoliya
Join Date: Nov 2022
Posts: 66
Rep Power: 4  |
Hello REEF3D Team,
When I am exporting an STL file in REEF3D, it has different dimensions as I am created in CAD software. For Example, i have created a circular pile in CAD software with a Diameter of 0.15 m, but in REEF3D, it is showing 150m. I have also tried to scale down it with 0.001, but it not working Thank you |
|
|
|
|
|
January 17, 2024, 04:24
|
|
#2 |
|
Member
Alexander Hanke
Join Date: Dec 2023
Location: Trondheim
Posts: 45
Rep Power: 4 |
Could it be that you are looking at the measurements on some kind of scale in your CAD software, that might explain the difference?
Last edited by harenaobsidet; January 17, 2024 at 11:24. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 09:46 |
| what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 02:22 |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 22:53 |
| [Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0 | Seroga | OpenFOAM Community Contributions | 9 | June 12, 2015 18:18 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 20:08 |
Linear Mode
