Convergence problems with simpleFoam (Airfoil) -- CFD Online Discussion Forums

February 27, 2015, 16:15

Convergence problems with simpleFoam (Airfoil)

sisi

Member

Join Date: Mar 2014

Location: Austrian abroad in Germany

Posts: 48

Rep Power: 12

Followed this tutorial (openfoamtutorial2012.pdf) but simpleFoam is not converging. The attachment is the OpenFOAM case (except the mesh). Also tried to increase "endTime". Why does this happen? I am using OpenFOAM 2.3.

Attached Files

Tutorial-Durham-University.zip (10.9 KB, 2 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 12:12
Problem with restart solution in shape_optimization.py	robyTKD	SU2 Shape Design	21	May 29, 2013 10:26
[ICEM] issue occur after extrude 2D airfoil mesh and convergence problem in CFX	shiyun	ANSYS Meshing & Geometry	4	May 9, 2012 20:55
SST SimpleFoam Convergence Problems	camoesas	OpenFOAM	23	September 27, 2011 17:27
convergence problems using simpleFoam	sebbi	OpenFOAM Running, Solving & CFD	3	November 25, 2009 16:27

All times are GMT -4. The time now is 11:26.