 |
 |
 |
|
|
|
[Sponsors] | ||||
October 13, 2014, 13:56
|
Problems with the meshing
|
#1 |
|
New Member
christian
Join Date: Oct 2014
Posts: 2
Rep Power: 0  |
Hi,
after installing Helyx i do have some problems with the meshing. I get this error. (It seems that there is no lamd running on the host xxxxx-Lenovo-IdeaPad-U530-Touch. This indicates that the LAM/MPI runtime environment is not operating. The LAM/MPI runtime environment is necessary for the "mpirun" command. Please run the "lamboot" command the start the LAM/MPI runtime environment. See the LAM/MPI documentation for how to invoke "lamboot" across multiple machines.) Maybe someone could help me regards ch |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Problems meshing an impeller with snappyHexMesh | kandelabr | OpenFOAM Meshing & Mesh Conversion | 13 | June 9, 2017 07:18 |
| [GAMBIT] Problems while meshing a 3d CAD model | CFDST | ANSYS Meshing & Geometry | 28 | January 7, 2013 02:52 |
| [ICEM] Problems with meshing of wind turbine | Dosis | ANSYS Meshing & Geometry | 14 | November 13, 2012 06:41 |
| Problems of Icem meshing about Conical Forebody | raja2010 | ANSYS Meshing & Geometry | 2 | December 6, 2010 10:20 |
| Problems with Meshing: Collapsed Cells | Emmanuel Resch | Siemens | 1 | July 30, 2007 04:02 |
Linear Mode
