Inflation mesh of an elliptical surface -- CFD Online Discussion Forums

December 5, 2016, 05:34	Inflation mesh of an elliptical surface	#1
vijayadityah New Member Join Date: Dec 2016 Posts: 11 Rep Power: 10	Hi. I have a geometry where a cylindrical body(a) cuts another cylindrical body(b) at an angle. This led to an elliptical surface at the intersection. I need to mesh these bodies and need to give an inflation to (a). But I am unable to create an inflation as there are two different kinds of surfaces on both the ends of the body. Any ideas on how I can create inflation layers on this? I am using ANSYS Fluent.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
y+ = 1 boundary layer mesh with snappyHexMesh	Arzed23	OpenFOAM Running, Solving & CFD	6	November 23, 2022 16:15
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 07:41
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 10:38
[snappyHexMesh] Problem with Sanpper, surface still Rough	Zephiro88	OpenFOAM Meshing & Mesh Conversion	7	November 5, 2014 13:05
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19

All times are GMT -4. The time now is 14:54.