Wind Turbine (Periodic Faces Meshing Problems)

Seancooke89 · March 13, 2013, 12:12

Hi All,

I am pretty new to CFD software packages. I am currently trying to develop a mesh for a Wedge shaped domain ( with a turbine blade inside ) . I need to make the sidewalls of the domain periodic but identical mesh is required and I am really struggling to find the solution to this problem. I have attached the file I am currently working on. (Left Wall and Right Wall are the ones which I want to be periodic)
It is possibly just a box I need to tick but any help would be much appreciated

Regards,
Sean

Far · March 16, 2013, 11:39

which meshing software you are using?

March 13, 2013, 12:12	Wind Turbine (Periodic Faces Meshing Problems)	#1
Seancooke89 New Member Sean Cooke Join Date: Mar 2013 Posts: 4 Rep Power: 13	Hi All, I am pretty new to CFD software packages. I am currently trying to develop a mesh for a Wedge shaped domain ( with a turbine blade inside ) . I need to make the sidewalls of the domain periodic but identical mesh is required and I am really struggling to find the solution to this problem. I have attached the file I am currently working on. (Left Wall and Right Wall are the ones which I want to be periodic) It is possibly just a box I need to tick but any help would be much appreciated Regards, Sean

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
please help in simulating a wind turbine blade in 6 DOF ????....	usman naseer	Main CFD Forum	2	March 10, 2016 03:53
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 10:38
Vertical Axis Wind Turbine	atorninc	Main CFD Forum	3	March 6, 2013 05:38
[ICEM] periodic tolerance icem tetra / hexa	Jonathan	ANSYS Meshing & Geometry	4	December 22, 2011 12:26

March 16, 2013, 11:39		#2
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	which meshing software you are using?