Home > Forums > Software User Forums > ANSYS > FLUENT

azimuthal start and stop angle

Updated Threads

Reply

Search this Thread

September 25, 2008, 04:48	azimuthal start and stop angle	#1
sina Guest Posts: n/a	Hi I m working on a windshield washer.I choose DPM to simulate that. Could u please explain me What azimuthal start and stop angle are in plane orifice atomizer model? Thx.

September 30, 2008, 02:05	Re: azimuthal start and stop angle	#2
Prasad Guest Posts: n/a	Put azimuthal angle from 0 deg to 360 deg. I understand that essentially you're trying to specify the flow through tiny orifice using orifice atomizer model. Please correct me if I'm wrong.

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transient DPM-About Start Stop times	Julie	FLUENT	3	January 24, 2014 08:39
azimuthal angle in plane orifice atomizer model	sina	FLUENT	0	September 23, 2008 02:23
Stop without res?	Camilo Costa	CFX	5	April 17, 2008 23:48
Should I stop the run? Need urgent help.	Sam	CFX	4	October 20, 2005 19:50
phoenics stop	Olfa Daboussi	Phoenics	0	May 26, 2005 05:14

All times are GMT -4. The time now is 07:50.