 |
 |
 |
|
|
|
[Sponsors] | ||||
December 23, 2006, 14:01
|
Turbulence Model Boundary Condition
|
#1 |
|
Guest
Posts: n/a
|
I'm doing some CFD simulition about the external flow over the hydrofoil. When I use the k-e model, how to set the turbulence Turb. Kinetic Energy K and the Turb. Dissipation Rate e. In the manual, the k and e can be calculated from the turbulence intensity. For my case, if the velocity is about 0.2m/s, what about the turbulence intensity, how to calculate it, thank you very much for your help.
|
|
|
||
|
December 23, 2006, 14:01
|
Re: Turbulence Model Boundary Condition *NM*
|
#2 |
|
Guest
Posts: n/a
|
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| External Radiation Boundary Condition for Grid Interface | CFD XUE | FLUENT | 0 | July 9, 2010 03:53 |
| CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 15, 2009 22:25 |
| Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 08:15 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
| New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 07:18 |
Linear Mode
