 |
 |
 |
|
|
|
[Sponsors] | ||||
August 24, 2006, 20:13
|
inlet profile for 3D problem
|
#1 |
|
Guest
Posts: n/a
|
Hi, i am trying to set the inlet velocity profile but i have some problems.
it is 3D,but velocity varies only with z direction on the inlet plane.How could i set it? thanks a lot! |
|
|
||
|
August 24, 2006, 22:31
|
Re: inlet profile for 3D problem
|
#2 |
|
Guest
Posts: n/a
|
Hi, did you try to change from "Normal to plane" to "components"? Doing that you will can put the wind coming from the direction that you want.
Hope this helps! |
|
|
|
||
|
August 25, 2006, 01:26
|
Re: inlet profile for 3D problem
|
#3 |
|
Guest
Posts: n/a
|
UDF
|
|
|
|
||
|
August 25, 2006, 08:46
|
Re: inlet profile for 3D problem
|
#4 |
|
Guest
Posts: n/a
|
thanks a lot!i will try again!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TimeVaryingMappedFixedValue for Direct Numerical Simulation inlet | johndeas | OpenFOAM | 5 | May 21, 2014 08:11 |
| How to apply velocity profile at inlet | Sam | CFX | 12 | April 1, 2012 07:52 |
| problem with importing and exporting profile BC | Gui | CFX | 2 | July 26, 2007 09:50 |
| problem with velocity inlet profile file | Duncan | FLUENT | 3 | November 21, 2005 08:28 |
| Create hemisphere like velocity profile at inlet | Nelson | Main CFD Forum | 3 | July 27, 2005 13:05 |
Linear Mode
