Home > Forums > Software User Forums > ANSYS > FLUENT

how to mesh the tip region of cyclone?

Updated Threads

Reply

Search this Thread

January 23, 2005, 02:17	how to mesh the tip region of cyclone?	#1
Lcw Guest Posts: n/a	There are a very tip region between the rectangular inlet and cylinder body, mesh quality of this region is very important for convergence. When I mesh the rehion, there always exist one or two meshes with the highly skewed >0.98. How to mesh this tip region? Please give me some advices! Thanks

January 24, 2005, 04:19	Re: how to mesh the tip region of cyclone?	#2
zxaar Guest Posts: n/a	break it into much smaller volumes ,, thats the only way

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem with Min/max rho	tH3f0rC3	OpenFOAM	8	July 31, 2019 10:48
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 04:52
Problem in defining porous region on an imported tetrahedral mesh	run_cfd	OpenFOAM Pre-Processing	0	May 24, 2011 03:15
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 15:09
how to mesh the tip region of cyclone?	Lcw	FLUENT	1	January 8, 2005 08:46

All times are GMT -4. The time now is 09:04.