|
[Sponsors] |
August 29, 2022, 15:13 |
2d planar simulation setting
|
#1 |
New Member
Chenxi
Join Date: Apr 2022
Posts: 11
Rep Power: 4 |
Hi, I am doing the VOF simulation in a T-shape pipe as shown in the pic. Now, I'd like to simplify the simulation as a 2d planar model along the pipe center line. But I am confused how to set the refernce value as the diameter for each pipe is different. Besides, how should I set the boundary condition for this 2d planar simulation? I used the velocity inlet and pressure outlet for 3d simulation at the pipe ends. Should I use the velocity inlet bc with the same value for 2d simulation or replace velocity inlet with massflow inlet? Thanks in advance.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help with setting up BC for Pressure in stirred tank multiphase simulation | MazenDraw | OpenFOAM Pre-Processing | 1 | June 5, 2021 03:52 |
Setting up 3D simulation for external gear pump | 310toumad | FLUENT | 2 | February 5, 2019 09:12 |
fvscheme setting in Actuator Line simulation | gxy200992243 | OpenFOAM Running, Solving & CFD | 0 | June 18, 2014 10:23 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
Setting up Flow around a Wing Simulation help | Atella | CFX | 3 | January 3, 2010 11:51 |