 |
 |
 |
|
|
|
[Sponsors] | ||||
January 9, 2014, 07:11
|
Open both case and data at the same time
|
#1 |
|
Senior Member
Meimei Wang
Join Date: Jul 2012
Posts: 494
Rep Power: 16  |
Hi,
Every time when I start fluent case by double clicking on the case file. Then I still need to open the data file to continue the simulation or view the results. It's not like CFX that I can click directly on the result file then open it. Fluent doubles the operations to open a simulation result file. I'm wondering is there any more direct way to open the fluent result file?
__________________
Best regards, Meimei |
|
|
|
|
|
January 10, 2014, 13:58
|
|
#2 |
|
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 29 |
no, when you double-click on the case file, a temporary journal file is created with one function, that is to read the case file, which is already good, it saves you time from reading the case ...
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reconstruction of the parallel case with dynamic mesh | makaveli_lcf | OpenFOAM Post-Processing | 7 | October 18, 2023 12:28 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
| AMI interDyMFoam for mixer nu problem | danny123 | OpenFOAM Programming & Development | 8 | September 6, 2013 03:34 |
| IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 03:58 |
| How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 18:27 |
Linear Mode
