 |
 |
 |
|
|
|
[Sponsors] | ||||
February 15, 2013, 06:37
|
Laminar Separation Bubble and transition
|
#1 |
|
Member
Mamdouh
Join Date: Dec 2012
Location: Calgary, Alberta, Canada
Posts: 39
Rep Power: 13  |
Hello everybody,
I am simulating the laminar separation bubble over thin 2D airfoils at low Re Re from 70 k to 200 k , using Transition SST model. I explored the threads and posts about this issue, but I am confused in some points, hopping to be clarified ... 1- Should I use unsteady simulation to capture LSB and transition location? 2- How can I specify the bubble geometry and transition location? pressure contours?velocity contours? Cp- plateau? stream function? all? thanks in advance Mamdouh Last edited by mrenergy; February 17, 2013 at 09:58. |
|
|
|
|
|
February 17, 2013, 09:51
|
|
#2 |
|
Member
Mamdouh
Join Date: Dec 2012
Location: Calgary, Alberta, Canada
Posts: 39
Rep Power: 13 |
any help?
thanks |
|
|
|
|
|
|
June 12, 2023, 09:50
|
|
#3 |
|
New Member
Xu Yifan
Join Date: Jun 2023
Posts: 2
Rep Power: 0 |
Have you solved this problem?
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Laminar to Turbulent transition information in Fluent 12.1?? | aerobharath | FLUENT | 0 | September 22, 2011 19:29 |
| Laminar bubble separation | Gilles | CFX | 1 | July 24, 2008 22:57 |
| Separation bubble, hypersonic compression corner | ben akih | CFX | 3 | December 10, 2006 17:33 |
| Laminar separation bubble | Axilleas Tsompanos | FLUENT | 5 | August 6, 2004 13:24 |
| V2F model and laminar separation | Romuald | Main CFD Forum | 1 | February 17, 2003 05:05 |
Linear Mode
