|
[Sponsors] |
ERROR: could not find a side polygon that surrounds the negative area side polygon |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 2, 2017, 03:34 |
ERROR: could not find a side polygon that surrounds the negative area side polygon
|
#1 |
New Member
Yupeng_Huang
Join Date: May 2017
Posts: 1
Rep Power: 0 |
simulate an LNG engine, no problems when the case setting but if i run the simulation i find this error, how i can solve it ?
ERROR: could not find a side polygon that surrounds the negative area side polygon this means the stl file probably has problem areas 1.082260e-001 6.647034e-002 2.891710e-0011.082260e-001 6.647034e-002 2.891710e-0011.082260e-001 6.647034e-002 2.891710e-0011.082260e-001 6.647034e-002 2.891710e-001 |
|
May 2, 2017, 11:37 |
|
#2 |
New Member
Chaitanya Ghodke
Join Date: May 2017
Location: Convergent Science, Madison WI
Posts: 29
Rep Power: 9 |
Do you have any overlapping or low area triangles at this location?
__________________
--------------------------------------------- Chaitanya D. Ghodke, Ph.D. Senior Research engineer Convergent Science Inc. --------------------------------------------- |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error: could not find a side polygon [...] | rrschor | CONVERGE | 12 | December 8, 2018 06:07 |
CFX-Pre problem, pls help!!! | cth_yao | CFX | 0 | February 17, 2012 00:52 |
Problem Building OF on Centos cluster (no admin rights) | CKH | OpenFOAM Installation | 5 | November 13, 2011 06:32 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |