How to avoid interface separation? -- CFD Online Discussion Forums

January 8, 2008, 14:35	How to avoid interface separation?	#1
Fabian Guest Posts: n/a	Hi, I have an interface of two motion domains. Their mesh motion are set as unspecified. During the simulation one side of the interface is pulled, causing the separation of the interface sides. Is there a way to keep the two interface sides attached without prescribing mesh displacement (keeping the unspecified option)? Thanks a lot, Fabian

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05
CFX Solver Memory Error	mike	CFX	1	March 19, 2008 08:22
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 21:09

All times are GMT -4. The time now is 11:06.