Working on Evaporator. Not getting results as expected

vijay755 · August 31, 2013, 08:33

Hi All,
I am working on a evaporator model.
I am tryin to solve it with humidity.
Refrigerant passing through tubes are at 1.8'c and air flowing over the tubes is at 27'c
I certainly see some heat transfer , but at the end of simulation what I see is temperature throughout the System is 27'c. which is not in the real scenario.
only near the inlet of refrigerant into the tubes temp is less than 27'c. but other than that the whole system attains a temperature of 27'c.
I dont know what am I missing in the B.C's
Please Help

ufxfor · August 31, 2013, 08:39

Hi every one this is Forex Market in India
online commodity trading

I certainly see some heat transfer , but at the end of simulation what I see is temperature throughout the System is 27'c. which is not in the real scenario.
only near the inlet of refrigerant into the tubes temp is less than 27'c. but other than that the whole system attains a temperature of 27'c.
I dont know what am I missing in the B.C's
Please Help

August 31, 2013, 08:33	Working on Evaporator. Not getting results as expected	#1
vijay755 New Member vijay kadli Join Date: May 2010 Posts: 3 Rep Power: 16	Hi All, I am working on a evaporator model. I am tryin to solve it with humidity. Refrigerant passing through tubes are at 1.8'c and air flowing over the tubes is at 27'c I certainly see some heat transfer , but at the end of simulation what I see is temperature throughout the System is 27'c. which is not in the real scenario. only near the inlet of refrigerant into the tubes temp is less than 27'c. but other than that the whole system attains a temperature of 27'c. I dont know what am I missing in the B.C's Please Help

August 31, 2013, 08:39	Autodesk Simulation CFD	#2
ufxfor New Member Join Date: Aug 2013 Posts: 1 Rep Power: 0	Hi every one this is Forex Market in India online commodity trading I certainly see some heat transfer , but at the end of simulation what I see is temperature throughout the System is 27'c. which is not in the real scenario. only near the inlet of refrigerant into the tubes temp is less than 27'c. but other than that the whole system attains a temperature of 27'c. I dont know what am I missing in the B.C's Please Help

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries	NickG	OpenFOAM Installation	3	December 30, 2019 01:21
Problem: Very long "write" time (~2h-3h) for results and transient results	Shawn_A	CFX	16	April 12, 2016 21:49
Mesquite - Adaptive mesh refinement / coarsening?	philippose	OpenFOAM Running, Solving & CFD	94	January 27, 2016 10:40
Field Mapper- Mesh refinment	mm.abdollahzadeh	OpenFOAM Programming & Development	2	January 24, 2013 10:18
Transient Run - Output "Time" in partial results?	evcelica	CFX	2	May 16, 2012 22:36