Multi Element Airfoil

Firzen822 · December 3, 2022, 19:09

Hello,
I am conducting my first simulation on a multi element airfoil on Ansys Fluent, I would like to know if I am doing good or not, because I am unsure of my progress.

I also need to do this study for a specific Reynolds number, any help with that/
Thank you, any insight on this would be very helpful.

mluckyw · January 5, 2023, 08:31

Does the simulation converges numerically? and if you have the experimental data, please do compare it. its the most foolproof way to validate the result.

Could you increase the number of contour, because in your picture the deviation is very large from one color to the next and could be wrongly interpreted.

Assuming the contour would not changed after increasing in contour number, I think there's a mistake when you set the inlet pressure. CMIIMW

December 3, 2022, 19:09	Multi Element Airfoil	#1
Firzen822 New Member Lalo Star Join Date: Dec 2022 Posts: 1 Rep Power: 0	Hello, I am conducting my first simulation on a multi element airfoil on Ansys Fluent, I would like to know if I am doing good or not, because I am unsure of my progress. I also need to do this study for a specific Reynolds number, any help with that/ Thank you, any insight on this would be very helpful.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ffd_control_point_2d	feiyi	SU2	4	September 30, 2019 13:42
[Gmsh] 3D Mesh conversion from gmsh-2.5.0 to OpenFOAM	Ancioi	OpenFOAM Meshing & Mesh Conversion	17	January 9, 2019 00:50
Identifying Markers in a CGNS Mesh	tjim	SU2	3	October 12, 2018 02:21
multi element forceCoeffs	s.m	OpenFOAM Running, Solving & CFD	0	May 6, 2013 06:16
[GAMBIT] Multi Element Airfoil Meshing	wanfuhh	ANSYS Meshing & Geometry	1	May 6, 2013 03:45

January 5, 2023, 08:31		#2
mluckyw Member Chrowale Join Date: Sep 2021 Location: Bandung, Indonesia Posts: 63 Rep Power: 5	Does the simulation converges numerically? and if you have the experimental data, please do compare it. its the most foolproof way to validate the result. Could you increase the number of contour, because in your picture the deviation is very large from one color to the next and could be wrongly interpreted. Assuming the contour would not changed after increasing in contour number, I think there's a mistake when you set the inlet pressure. CMIIMW