|
[Sponsors] |
November 9, 2022, 13:35 |
Problems with mesh/skew of a wing
|
#1 |
New Member
Geovane
Join Date: Jun 2022
Posts: 6
Rep Power: 4 |
Hello everyone!
I've been struggling with a problem with my mesh for a while and it's been impossible to find the source of it. Basically, I have the domain seen in the first two pictures, with an e. skew of 0.66 (which is not great, but adjustable). However, when I set the nodes to the lines at the extent of the wing (picture 3) the skew goes insanely low and it turns into a mess. I checked for any incorrect association but didn't find any. Does anyone may have an idea on what's going on? Any insights are welcome! Thanks! |
|
November 10, 2022, 03:50 |
|
#2 |
Senior Member
|
You can right click on the blocking->edges->show association.
Check whether all the blocks in the fluid zone are in the fluid blocking. This looks more like an association problem to me. Make sure you have selected copy- Parameters to all parallel edges. Lastly you can also you do face association to a specific surface part (inlet, outlet, what have you) to ensure associations are okay! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Front wing mesh problems | Emmanuel Biocca | ANSYS Meshing & Geometry | 0 | March 30, 2022 13:54 |
Wing FSI simulation: Shell elements or 3D solid body? | frossi | CFX | 3 | June 15, 2016 20:02 |
[ANSYS Meshing] Wing with winglet mesh problems | MAH_cape | ANSYS Meshing & Geometry | 1 | May 31, 2016 04:06 |
[snappyHexMesh] Problems with coarse/unsnapped cells in snappyHexMesh | scareneb | OpenFOAM Meshing & Mesh Conversion | 2 | August 13, 2014 07:13 |
[snappyHexMesh] Meshing 3D wing (hydrofoil) fails | klausb | OpenFOAM Meshing & Mesh Conversion | 0 | December 28, 2011 14:26 |