|
[Sponsors] |
June 6, 2018, 15:08 |
Problem in generating mesh
|
#1 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
I am new in Ansys Workbench. According the following figure, I don't know that why top face (Face meshing 3) is not mapped. I am grateful that guide me in this case. The ansys File (workbench) is as follows: http://www.mediafire.com/file/6895iw...hout+slice.rar Another question: How can I change number of cell inside Holes? For this work, Should i project a edge on these holes? Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[TGrid] Problem when generating volume mesh "tg-is-point-in-region" | Tuck | ANSYS Meshing & Geometry | 1 | April 16, 2017 12:19 |
[snappyHexMesh] SHM problem : KVLCC2 with appendage mesh | sc.park | OpenFOAM Meshing & Mesh Conversion | 1 | March 13, 2016 13:28 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
[ICEM] ICEM Structured Mesh Problem | OMJT | ANSYS Meshing & Geometry | 3 | March 22, 2013 10:06 |
[ICEM] Problem making structured mesh on a surface | froztbear | ANSYS Meshing & Geometry | 4 | November 10, 2011 08:52 |